Utilizing entirely passive filtration technology, WaveGuide greatly reduces the common mode noise that travels along power cords, interconnects and speaker cables. Common mode noise can cause power supplies to modulate in all types of audio and video electronics. This type of noise, in conjunction with the modulation it produces, contributes to undesirable increase of grain, glare and loss of dimensionality.
The WaveGuide is designed to fit around power, interconnect or loudspeaker cables. Precision machined from a solid block of Delrinฎ, WaveGuide has excellent dielectric properties, vibrational inertness and is relatively soft (to avoid the possibility of cosmetic damage to adjacent equipment.)
To install, simply open the WaveGuide using an Allen wrench (supplied), lay your cable in the bottom milled channel, then place the top half over the cable and tighten the attachment screws. Since the WaveGuide is completely passive and requires nothing more than your cable pass through it, is easy to move up and down the cable to "tune" the entire system.
The sonic improvement afforded by the WaveGuide
is nothing less than astonishing. Bass is tighter, deeper and more
articulate. Hollow-bodied acoustical instruments take on a fuller and much
more life-like presentation. The midrange is rendered much more naturally
without even a hint of glare or edge. Vocals take on a realistic presence
within an accurately portrayed three-dimensional acoustical space. Highs such as strings loose the "steel" and
become sweet and silky. You could spend thousands of dollars and hear less of an
improvement than with
WaveGuide .
- Recommended for use on power, audio, video and
digital cables.
- Passive inductive circuit improves low-frequency
noise attenuation.
- Fits around any cable up to 5/8" (1.6 cm.)
- Complete installation in less than five minutes.
Cable Capacity: up to 5/8" diameter (16 mm)
Weight: 12 ounces (340 grams)
Dimensions: 4 x 2 x 1 5/16"
(10.16 x 5.08 x 3.33 cm)